Dodge Dakota ForumDodge Dakota PhotosDodgeDakota.net Membership
  Forums   Forum Tools
12:16:36 - 05/19/2024

V8 Dakotas
FromMessage
Matt
Dodge Dakota
JOIN HERE


12/24/2010
15:24:32

Subject: RE: 4.7L throttle position sensor
IP: Logged

Message:
Thank you for all that contributed to this post.

With my 2000 Dodge Dakota 4.7 manual, my truck was working perfectly for years ever since i bought it new. About 12 month ago, i started getting the surging and low idling (amplified when the Environmentals were on) when I came to a stop; as time went on, the surging got worse. Replaced the Throttle Position Sensor ($35) and the problem appears to have gone away.

Thanks again!!!



scott
Dodge Dakota
JOIN HERE
 Email

9/03/2011
09:53:21

RE: 4.7L throttle position sensor
IP: Logged

Message:
found this site while searching for answers on why my dakota was acting the way it was. my truck was doing exactly what you guys are describing here. acts like it's "slipping" out of gear when traveling at a steady speed. erratic idle speeds etc. changed the $30 sensor and it's like new. thanks for the info you guys put up here. I wish i would have found this place a long time ago. Thanks again.



alisa
Dodge Dakota
JOIN HERE
 Email

5/08/2012
17:21:43

RE: 4.7L throttle position sensor
IP: Logged

Message:
i have a 2003 dodge dakota v8 4.7l and was wondering if any 1 can help me with locating the trottle position sensor. my truck does the same thing revs up and down n goes down so much it stalls out. checked the code n it says po121. so i would like to replace the sensor to keep myu truck a lil longer. it has 194,673 miles so i know its getting a lil worn. thanks



daddio
Dodge Dakota
JOIN HERE
 Email

5/08/2012
18:01:18

RE: 4.7L throttle position sensor
IP: Logged

Message:
Alisa, if you can find the throttle body it should be opposite where the throttle cable connects to it.



Harvey
Dodge Dakota
JOIN HERE
 Email

7/04/2012
07:40:57

RE: 4.7L throttle position sensor
IP: Logged

Message:
I recently bought a 2008 DAk QC 4.7 auto 44000 miles.It has developed a miss at any held speed 35 to 55 mph. Feel like you are running against a gusting head wind. Idle is good, acel is good. Changed top plugs with no change, tried gas additive no change. NO CODES. Any idea what the problem might be.



jpconard
Dodge Dakota
JOIN HERE
 Email

7/14/2012
15:39:11

RE: 4.7L throttle position sensor
IP: Logged

Message:
Hey, my original thread. Haven't been here in a while. Mine has almost 203,000 on it now, typical issues, rust just starting around rear wheel wells (cause they stamp weld two pieces of steel together and dirt/salt stuff gets trapped) and warped rotors always come back, even with premium rotors/pads.

Couple other things I found -
1) transmission filter (flat one) seal is loose causes stalling when coming to a stoplight and sluggish starts when cold, air must leak in through this location. Solution replace filter/seal making sure it is tight fit, fixed transmission issues.

2) After 12 years A.C. needed freon.

3) heater core went bad, big job, needed some help on that one.

4) Ball joints on one side, inner tie-rod on other, hubs on both.

Just got 4th set of tires, 4th set of plugs (Autolite standards), 1st new shocks. Running pretty good even in the 100+ heat, except for fan clutch locking up a lot and robbing power/making noise.





Curtis
Dodge Dakota
JOIN HERE
 Email

7/18/2012
14:11:10

RE: 4.7L throttle position sensor
IP: Logged

Message:
I have replaced the TPS, MAP, MAF sensors and still having the P00068 engine code popping up. It is doing the transmission slipping/sluggish start from a stop. I replaced the two vaccum lines as well. Any other suggestions?



Bob S.
Dodge Dakota
JOIN HERE
 Email

8/24/2013
20:00:15

RE: 4.7L throttle position sensor
IP: Logged

Message:
I had this engine surging issue where the rpm's would shoot up and I would lose power. I had the TPS code come up. I changed the TPS and still had the issue and light. I replaced the plug and wiring to the TPS. and eventually the PCM since it was under warranty anyway. Still had the light and the surging. I then replaced the IAC motor and it drives good now but I still have the TPS code. Have reset several times with the code reader but it immeadiately pops right back up. I have not put but a few miles on it since doing this. Does it possibly need some miles to adjust to the new TPS.



  <<Original Post <<Previous Page P 3


Post a reply to this message:

Username Registration: Optional
All visitors are allowed to post messages


Name:
Email:
Notify me when I get a reply to my message:Yes  No

Icons:            

          

Subject:
Message:
 



Home | Forums | Members | Pictures | Contact Us

This site is in no way affiliated with Chrysler or any of its subsidiaries.