| From | Message |
92Dakota
Dodge Dakota
JOIN HERE
11/25/2002
19:33:33
|
 Subject: Flamed Dak
IP: Logged
Message:
Hey
Nice truck. I have a 1992 Dakota and I want to do something similar. I could use some help on different things.
How did you lower your front and rear? Where is the cheapest place to get spindles and coils? If I were to lower it 4" in the front, would I have to worry about tire rub?
How do you get the glue off of the place where the side panels were?
Thanks
|
1Flamed92Dak
GenII
11/26/2002
21:11:27
| RE: Flamed Dak
IP: Logged
Message:
First of all my truck is a SPORT model so i didn't have too remove any door guards.As for Lowering my truck its stock ride height up front and the rear is 3 inches. Spindles there are a few of them availible Bell Tech and Western Chassis are a couple of options as for the Rear its either Blocks or Shackles and it's pretty easy. Now the adhesive use 3M adhesive remover it takes a while but it will get the job done. I have seen Dakotas that have a severe drop and run the R/T wheels but i like the Muscle Truck Look not the Slammed Look
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
