| From | Message |
HeyMikey
Dodge Dakota
JOIN HERE
11/18/2003
09:18:21
|
 Subject: MSD 6a help needed
IP: Logged
Message:
Ok, this may be a dumb question, but I don't know a whole lot about wiring or much anything electrical in a truck. I have the msd install harness, and I know where the coil is and where to hook that end up, but I can't figure out where the other end goes. If someone could give me some dumb dumb directions, I mean really break it down barney style with locations and what not, then it would be really appreciated. My truck is a 97 318.
|
IntenseDak39
*GenIII*
11/18/2003
10:09:06
| RE: MSD 6a help needed
IP: Logged
Message:
its pretty easy..
there are two wires that plug into the bottom of the coil via a harness. Cut those two wires... i believe one is green/orange and the other is black/gray. When you cut the wires you then have four wires in total... The small red wire from the msd goes to the green/orange on going to the computer... the small white wire goes to the black/gray going to the computer. The orange wire goes to the green/orange handing off of your coil. The small black wire goes to your black/gray hanging off of your coil.
The big red goes to battery positive and the big black wire goes to the battery negative
if you need any other help here ya go:
http://www.msdignition.com/pdf/6series.pdf
scroll down to page 10
|
HeyMikey
Dodge Dakota
JOIN HERE
11/18/2003
11:45:45
| RE: MSD 6a help needed
IP: Logged
Message:
oooooooh. I thought there was two separate places, but its all from the same wire. Ok, thanks a lot.
|
IntenseDak39
*GenIII*
11/18/2003
12:14:31
| RE: MSD 6a help needed
IP: Logged
Message:
no problem... i did the same thing. Called up MSD techline and asked them, "where are these other two wires?" ... "fromt the two you cut, sir"
DUH!!!
... i felt kinda stupid after that.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
