| From | Message |
Lee
Dodge Dakota
JOIN HERE
11/07/2004
21:09:42
|
 Subject: HELP !!! 2nd- 3rd shift problem
IP: Logged
Message:
I have an 02' rt 5.9 with 30,000 miles on it, and my tranny is
acting uo now. When i step on the gas to the floor from a stop it
will shift great into second apx 4,800 rpm , than second to third
it shifts at 4,100 rpm and bogs doun the truck alot, than third to
O/D again it shifts at 4,800 rpm which is where it should be.
this has just started and i dont know why? also downshifting it
bogs a bit too and i am stomping it hard too.
I was thinking that it might have been fluid level it seemed a bit
high when the truck was in neutral and running, so i lowered it
inbetween the high and low level when hot. still this problem
exists....
Any help would be greatly appreciated..
thanks -Lee
|
360R/T
Dodge Dakota
JOIN HERE
11/08/2004
00:47:01
| RE: HELP !!! 2nd- 3rd shift problem
IP: Logged
Message:
Hi Lee,
I have the exact same issue with my 01 R/T. It is a defective valve body in the transmission. Had it replaced and the 2-3 shift is back to normal. Good luck.
Joey Molnar
01 Silver CC R/T
13.8 @ 97.8
|
lee
Dodge Dakota
JOIN HERE
11/08/2004
09:07:10
| RE: HELP !!! 2nd- 3rd shift problem
IP: Logged
Message:
how much did that run you ? apx ..
|
rtspeeddemon
Dodge Dakota
JOIN HERE
11/08/2004
13:05:38
| RE: HELP !!! 2nd- 3rd shift problem
IP: Logged
Message:
Your truck is under warranty, who cares what it costs?
|
360R/T
Dodge Dakota
JOIN HERE
11/08/2004
23:36:12
| RE: HELP !!! 2nd- 3rd shift problem
IP: Logged
Message:
It was fixed under warranty. I think it cost me a $50 deductible.
|
Lee
Dodge Dakota
JOIN HERE
11/09/2004
08:48:11
| RE: HELP !!! 2nd- 3rd shift problem
IP: Logged
Message:
the dealer voided my warranty 6 momths ago for mods that were
done, plus the standard 3 year 30,000 is up now anyway. unless
there is something i dont know about for the tranny?
|
360R/T
Dodge Dakota
JOIN HERE
11/10/2004
00:20:28
| RE: HELP !!! 2nd- 3rd shift problem
IP: Logged
Message:
I couldn't find the receipt but I think it was around $500 for parts and labor.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
