Dodge Dakota ForumDodge Dakota PhotosDodgeDakota.net Membership
  Forums   Forum Tools
19:06:14 - 04/19/2024

V8 Dakotas
FromMessage
JT
Dodge Dakota
JOIN HERE
 Email

9/10/2003
00:02:18

Subject: Bad Belly Pan Gasket
IP: Logged

Message:
'99 CC 5.2, 4x4 90,000 miles. Just towed a 4500 lb. trailer 1200 miles and used almost 4 qts. oil. Also, a lot of pinging and knocking under acceleration. Looked down through throttle body and it appears to have some oil. Do I need a new gasket? Doesn't seem to use much oil under light loads....



jdllizard
Dodge Dakota
JOIN HERE


9/10/2003
01:48:11

RE: Bad Belly Pan Gasket
IP: Logged

Message:
Yes, your belly pan gasket is bad. Dealer charges $700, you can do it yourself for about $35 and several hours worth of work. My 99' CC 4X4 5.2L did the same thing around 38k miles, only has 43k on it now. Runs much better after the repair, but make sure you get a good metal replacement gasket, mine came from O'Reillys (Felpro) was a thin metal with some kind of rubber like coating.



Dakota_daze
Dodge Dakota
JOIN HERE
 Email

9/10/2003
08:55:44

RE: Bad Belly Pan Gasket
IP: Logged

Message:
I did mine this past weekend and the Felpro brand gasket is the way to go. I looked at the Carquest brand one that is sold in their stores and it was exactly like the piece of junk on my truck that was blown out in two places.



JT
Dodge Dakota
JOIN HERE
 Email

9/10/2003
09:42:58

RE: Bad Belly Pan Gasket
IP: Logged

Message:
Thanks for the tips, from everyhting I've heard, sounds like Felpro is the way to go. Had been thinking it needed replacing for a while. Since I've got the factory service manual, it shouldn't be too hard, I hope....



Mark
Forum Moderator
 User Profile


9/10/2003
09:48:12

RE: Bad Belly Pan Gasket
IP: Logged

Message:
What a job that was. You'll need new intake manifold gaskets. I didn't get the valve cover gaskets, I just turned them upside down for a new seal. If I had to do it again, I'd put an M1 intake on it since it was all off anyway. I was a little wary of the job when I did it just over 2 years ago but Bernd helped me out and talked me through it. Thank you Bernd!! I used felpro gaskets as well Dakota_daze. Its held up nicely over the past 30k or so miles. Below is a picture of me knee deep is sh1t. haha


-Mark Hryckiewicz
1993 Sport RC SB 5.2L Auto
DodgeDakotas.com

Dakota_daze
Dodge Dakota
JOIN HERE
 Email

9/10/2003
10:43:49

RE: Bad Belly Pan Gasket
IP: Logged

Message:
I used the directions that I downloaded from speedtweaks web site but I did not pull the distributor or the valve covers on my '99 5.2. I took my time and cleaned the throttle body and intake good. Put the 180 deg thermostat in and modified my TP sensor. Ran 1/3 can Sea Foam cleaner through the throttle body, dumped 1/3 can in the gas tank, and the rest in the oil. Ran it hard around the countryside and drained the oil and filled with Mobil 1. Runs like a new truck now.



Brad
Dodge Dakota
JOIN HERE
 Email

9/10/2003
10:57:02

RE: Bad Belly Pan Gasket
IP: Logged

Message:
I have a 99 RT w/ 86,000 mi. It has had an oil consumption problem for a while now. A quart about 1,200 to 1,500 mi. for the last year and a half. The intake manifold was pressure checked and there was no indication leaks. There is no oil build-up when I look down through the TB. No blue smoke w/ first start up. On its last tune the garage (reputable) where I take it did notice the #8 spark plug was a little damp w/ oil but not terrible. That was 4 months ago. Well, it just started knocking and pinging the other day. It has run fine w/ the slight oil leak till now. Is this the intake plenum/gasket problem? When this fix is done, is the gasket between the plenum and the intake, the plenum itself, and the gasket between the plenum and block replaced? If they are replaced are there now better gaskets or a better plenum to use? Manufacturers and part #s appreciated. The garage that I use is a block away from a Dodge dealer and can get their parts readily. I'm going to be trading the truck in within the next 6 months so I'm not interested in installing an M1.



Dakota_daze
Dodge Dakota
JOIN HERE


9/10/2003
11:17:47

RE: Bad Belly Pan Gasket
IP: Logged

Message:
Go to the web site linked below and print out the directions for the Technical Service Bulletin and take them to your garage and have them vacuum check it that way. http://www.speedtweaks.ca/tipsandtricks.php#bellypan



Brad
Dodge Dakota
JOIN HERE
 Email

9/10/2003
13:08:15

RE: Bad Belly Pan Gasket
IP: Logged

Message:
What are the part numbers for the Felpro gaskets? Thanks in advance, Brad



Dakota_daze
Dodge Dakota
JOIN HERE


9/10/2003
14:21:21

RE: Bad Belly Pan Gasket
IP: Logged

Message:
The Felpro parts from the Federal Mogul/FelPro web site.
60958-1 Throttle Body gasket
ES72169 Intake bolt set
MS95462 Upper set- phlenum gasket only
MS95392-1 Lower set - which I could not get and I think includes the phlenum gasket and the 2 intake to head gaskets



Curt
Dodge Dakota
JOIN HERE


9/14/2003
18:29:47

RE: Bad Belly Pan Gasket
IP: Logged

Message:
How much work is it to replace your belly pan gasket???



Dakota_daze
Dodge Dakota
JOIN HERE


9/15/2003
12:48:28

RE: Bad Belly Pan Gasket
IP: Logged

Message:
It is a fair amount of work. How fast you can do it depends on your available tools and how good you are. If you want to read the install steps, go to www.speedtweaks.ca/tipsandtricks.



Rob 1
Dodge Dakota
JOIN HERE
 Email

9/15/2003
23:11:27

RE: Bad Belly Pan Gasket
IP: Logged

Message:
Hughes Engines sells a good repair kit for the plenum gasket complete with bolts and new pan. Just go to hughesengines.com



Jim V
Dodge Dakota
JOIN HERE
 Email

4/30/2009
19:34:48

RE: Bad Belly Pan Gasket
IP: Logged

Message:
I have a 99 dakota that is using about a quart of oil every week or so.It also pings whenunder accellerated.I spoke with a few people who said it might be my rings how do i determine if its my belly pan gasket or not? Thanks



daddio
Dodge Dakota
JOIN HERE
 Email

4/30/2009
21:08:29

RE: Bad Belly Pan Gasket
IP: Logged

Message:
Take off the airhat on the TB. Hold the throttle open and look down into the intake manifold. Of course you need to do this without the engine running. If you see oil puddling in the intake, it's the belly pan gskt.

By the way, not to sound like an @ but you could start a new thread instead of draggin up an almost 6 yr old post. I just happened to stumble across it. Let us know what you find.

These motors usually don't start burning oil unless they've been very abused.



Shane parido
Dodge Dakota
JOIN HERE
 Email

12/02/2021
00:54:11

RE: Bad Belly Pan Gasket
IP: Logged

Message:
Need a picture of where it is and eat it lookslike



   P 1


Post a reply to this message:

Username Registration: Optional
All visitors are allowed to post messages


Name:
Email:
Notify me when I get a reply to my message:Yes  No

Icons:            

          

Subject:
Message:
 



Home | Forums | Members | Pictures | Contact Us

This site is in no way affiliated with Chrysler or any of its subsidiaries.